This attachment is used to attach a guitar strap to a guitar or ukulele that has only one strap pin.
Acoustic guitars and ukuleles have a horn only on one side (the bottom of the body).
Many of them do not have strap pins, so you will need a strap pin to attach a guitar strap.
It was necessary to add additional strap pins to the instrument.
By using this attachment, you will not need to make any modifications to your instrument.
In addition, the attachment can be installed without any modification to the guitar strap.
How to use
1. Use a coin or flathead screwdriver to loosen and remove the screw fittings (screw caps) on the back of each attachment.
2. Spread out the leather part of the attachment and place the guitar strap between the two pieces of leather.
3. Adjust the screw so that it can pass through the hole where the guitar strap pin would normally go, and tighten the screw cap removed in step 1 with a coin or flathead screwdriver.
*The screws may loosen with prolonged use, so be sure to check them before use.
To prevent screws from loosening, we recommend using a commercially available liquid thread lock (such as LOCTITE/243).
*If you would like the name engraving service, the name will be engraved in the area where the 708works logo would normally be, and the 708works logo will be engraved on the back.
Choosing a selection results in a full page refresh.
